Autorun image series problem

General discussion for MicroDicom viewer
Post Reply
petri
Posts: 2
Joined: Tue Nov 25, 2014 10:40 am

Autorun image series problem

Post by petri » Tue Nov 25, 2014 10:48 am

Hello

I've just started testing MicroDicom and I have a minor problem with the autorun. If I run via the run.bat, the program opens fine and opens also the dicom images. Unfortunately, it doesn't open them with all the data.

Example 1:
Image

Then if I search for dicom images from the same folder, the program finds all the data for the images, the series, patient info etc.
Example 2:
Image

Is there any way to open the images with all the data directly?

With regards
Petri

simeon
Site Admin
Posts: 251
Joined: Thu Jan 01, 1970 2:00 am
Location: Bulgaria
Contact:

Re: Autorun image series problem

Post by simeon » Wed Dec 03, 2014 11:17 am

This is very strange problem that I can't reproduce it.
Can you send me your images to test it. Please write me on support@microdicom.com
When you use run.bat or autorun, MicroDicom open DICOMDIR. You can change run.bat and autorun to use following command line:
mDicom.exe /scan <path_to_directory_to_scan>

petri
Posts: 2
Joined: Tue Nov 25, 2014 10:40 am

Re: Autorun image series problem

Post by petri » Fri Dec 05, 2014 8:12 am

Hello Simeon

Thank you for your help. The path in the bat and autorun.inf were slightly off (was DICOMDIR, should have been DICOM for my use ). I edited it and now it works like a charm :)

-Petri

simeon
Site Admin
Posts: 251
Joined: Thu Jan 01, 1970 2:00 am
Location: Bulgaria
Contact:

Re: Autorun image series problem

Post by simeon » Wed Dec 10, 2014 12:53 pm

:P

Post Reply